MC - Plug Bridge Jointing System
Sustained safety & durable flexibility
Nafutekt Plus is applied in layers using a "hot-on-hot" technique. A special graded aggregate is heated and placed in conjunction with a hot poured polymer modified bitumen. The resultant joint is durable, flexible and can withstand high dynamic loads while protecting the substrate against the ingress of water and contaminants.
The effects on the structure of seasonal and diurnal temperature changes are fully accommodated.
Instills design confidence
Nafutekt Plus is a tested and approved road surface joint system using polymer modified materials according to ZTV-Ing. Part 8 Section 2. Also approved for use by the NZTA for Contracts C658N & C677N.
Nafutekt Plus forms durable, waterproof, elastic traffic joints on bridges and load bearing structures. Nafutekt Plus is a more economic alternative to conventional hot poured deck joints that need frequent re-sealing.
Besides lasting protection for the structure Nafutekt joints give a smoother ride for motorists and cyclists. There is also a significant reduction in noise emission compared to conventional joints.
Long term flexibility
The design of joints in bridge decks has a critical effect on the performance and the service life of the bridge itself. This is especially true of decks with a short span or multi-sectioned bridges.
The design of the joints on short span or segmented bridges is a detail that has an enormous influence on the service life of the structure. A badly designed and/or poorly executed joint will lead to leaks and the penetration of de-icing salts or other contaminants as the bridge is subjected to dimensional changes. Combined with the dynamic loads imposed by traffic the damaging effects accumulate. Progressive deterioration of the road surface of the load bearing concrete elements will, if allowed to continue unchecked, eventually necessitate extensive and expensive repairs.
Areas of application
For all new and existing expansion and deck end joints
For sealing of hinged joint sections
Traffic joint sealing of segmental bridges
Cost-saving application with basic equipment
Fast application means short closures
Durable system means reduced expenditure for local and national highway authorities
Guaranteed MC system solution: Nafutekt Plus – tried and tested since 1989
Bridge Jointing Process
The Nafutekt Plus system forms a durable bond between the surfacing material and the structure, and accommodates changes in length caused by dynamic loads and temperature fluctuations.
Construction end joints in mastic asphalt or bituminous coatings:
Nafutekt as end joints on single span bridges. Bituminous road and bridge surfacings are made from asphalts with less than 6% voids.
Construction end joints in hot rolled asphalts:
Porous road surfaces with a void volume higher than 6% must not directly come into contact with a Nafutekt joint. The insertion of a 1m wide mastic asphalt strip on both sides of the joint is necessary.
Construction joints for mastic asphalt surfaces:
Nafutekt joints on multi segment bridges with a waterproof surface.
Construction joint for hot rolled asphalt:
Nafutekt on multi segment bridges with porous road surfaces. Surfaces with a void volume higher than 6% must not directly come into contact with a Nafutekt joint. The insertion of a 1m wide mastic asphalt strip on both sides of the joint is necessary.